Auto-sense intelligence fully automatic water level sensing
Fully automatic pump in 1 common compact housing
Pump and sensor are internally common wired for easy installation
No battery drain other than when the pump is in use
Optimised impeller design gives up to 10% higher fl ow than previous versions - at the same amperage
Built-in thermal cut-out (TCO) to protect the pump & the vessel
Supplied with back flow prevention - check valve in outlet port
Safety back-up operating mode prevents continuous running if the sensor or impeller is fouled by debris
How It Works:
The NEW Rule-Mate bilge pumps operate using an internal water level sensor. When the bilge water level reaches 62mm height the pump will automatically activate, removing water from the bilge. When the water level goes down to 16mm height the pump will automatically shut off until the water level rises again. Hidden air vents in the body of the pump helps prevent air locking in challenging plumbing installations. A check valve is included in the discharge nozzle to prevent water running back into the bilge. The smaller footprint of the NEW Rule-Mate pumps (only 2/3 the size of the previous versions) allows mounting in tighter spaces.
800 US Gallons per hour - 50 Litres per minute at open flow
640 US Gallons per hour - 40 Litres per minute at 1 metre head
Supplied with 1 x 20mm (3/4") threaded straight hose outlet
12 volt 800 GPH - 50 LPM 3.0 amp @ 12V, 3.7 amp @ 13.6V Fuse size 5 amp.
24 volt 800 GPH - 50 LPM 1.5 amp @ 24V, 2.0 amp @ 27.2V. Fuse size 4 amp.
| VOLTAGE |
AMPS |
| 12V |
3.0 Amps |
| 24V |
1.5 Amps
|
